Dietrich Bumper Installation:

 

d001s.jpg (54059 bytes) d002s.jpg (45679 bytes) d004s.jpg (41622 bytes) d003s.jpg (18515 bytes) d005s.jpg (45702 bytes) d008s.jpg (32353 bytes)
Test fitting     This is one of the cracks that was caused during shipping The interference with the intercooler (must have used a SLC to make the mold) Removing a section of the bumper support to allow the bumper to sit in
d010s.jpg (52237 bytes) d011s.jpg (38769 bytes) d012s.jpg (46125 bytes) d013s.jpg (41113 bytes) d014s.jpg (43638 bytes) d016s.jpg (45405 bytes)
Back from the body shop and they did a great job fixing the cracks! The back side of the repair Custom brackets to hold the bumper on the sides Bracket by itself To clear the intercooler I had to remove the lower guide and cut away some of the fiberglass I drill new holes for the bumper support so it would sit in about a 1/2" more (this allowed it to line up with the wheel well
d009s.jpg (52727 bytes) d017s.jpg (45954 bytes) d019s.jpg (54401 bytes) d023s.jpg (59889 bytes) d024s.jpg (55470 bytes) d025s.jpg (43813 bytes)
No bumper.. Bumper :-)        
seattle002as.jpg (44733 bytes) seattle003as.jpg (48243 bytes) corr001s.jpg (156026 bytes) corr003s.jpg (65601 bytes) corr004s.jpg (160722 bytes) corr005s.jpg (176491 bytes)
  Snow!!! BIG       
corr006s.jpg (79003 bytes) corr008s.jpg (68631 bytes) corr010s.jpg (59095 bytes) corr017s.jpg (76508 bytes) corr018s.jpg (70324 bytes)